在信息化時代，電磁環境日益復雜，鋼結構板房作為臨時或性建筑，其電磁兼容性能直接影響內部電子設備的穩定運行。通過構建材料屏蔽、接地優化、設備防護的三維體系，可顯著提升板房的抗干擾能力，保障電磁環境。

　　In the information age, the electromagnetic environment is becoming increasingly complex. As temporary or permanent buildings, the electromagnetic compatibility performance of steel structure panel houses directly affects the stable operation of internal electronic equipment. By constructing a three-dimensional system of material shielding, grounding optimization, and equipment protection, the anti-interference ability of the prefabricated house can be significantly improved, ensuring the safety of the electromagnetic environment.

　　一、電磁干擾的來源與影響

　　1、 Sources and Effects of Electromagnetic Interference

　　鋼結構板房面臨的電磁干擾呈現多元化特征：

　　The electromagnetic interference faced by steel structure panel houses presents diversified characteristics:

　　自然干擾源

　　Natural sources of interference

　　包括雷電電磁脈沖、太陽黑子輻射、宇宙射線等。雷電產生的瞬態電磁場強度可達10^4 V/m，足以干擾敏感電子設備。

　　Including lightning electromagnetic pulses, sunspot radiation, cosmic rays, etc. The transient electromagnetic field intensity generated by lightning can reach 10 ^ 4 V/m, which is sufficient to interfere with sensitive electronic devices.

　　人為干擾源

　　Human interference source

　　涵蓋無線電發射設備、電力電子設備、工業設備等。在板房周邊500米范圍內，若存在高壓輸電線路或中波廣播發射臺，將形成持續的電磁輻射場。

　　Covering wireless transmission equipment, power electronics equipment, industrial equipment, etc. Within a 500 meter radius of the prefabricated house, if there are high-voltage transmission lines or medium wave broadcasting transmitters, a continuous electromagnetic radiation field will be formed.

　　內部干擾源

　　Internal interference source

　　板房內的變頻設備、開關電源、熒光燈等，通過電源線或空間輻射產生干擾。實測顯示，未采取防護措施時，內部干擾可使設備誤碼率提升3個數量級。

　　The frequency conversion equipment, switch power supply, fluorescent lamps, etc. inside the board room generate interference through power lines or spatial radiation. Tests have shown that without protective measures, internal interference can increase the device's error rate by three orders of magnitude.

　　二、鋼結構板房的天然屏蔽優勢

　　2、 The natural shielding advantage of steel structure panel houses

　　鋼結構本身具備優異的電磁屏蔽性能：

　　The steel structure itself has excellent electromagnetic shielding performance:

　　法拉第籠效應

　　faraday cage

　　鋼框架與彩鋼板形成連續導電體，當電磁波入射時，在金屬表面產生感應電流，形成反向電磁場，實現能量抵消。理論計算表明，1.5mm厚鋼板對100MHz電磁波的屏蔽效能達40dB。

　　The steel frame and color steel plate form a continuous conductor. When electromagnetic waves are incident, induced currents are generated on the metal surface, forming a reverse electromagnetic field and achieving energy cancellation. Theoretical calculations show that the shielding effectiveness of 1.5mm thick steel plate against 100MHz electromagnetic waves reaches 40dB.

　　接地系統優化

　　Optimization of grounding system

　　通過鍍鋅扁鋼將鋼結構與接地網連接，接地電阻控制在1Ω以下。在雷擊或靜電放電時，可快速導引干擾電流入地，避免電位升高。

　　Connect the steel structure to the grounding grid through galvanized flat steel, and control the grounding resistance below 1 Ω. During lightning strikes or electrostatic discharges, interference currents can be quickly guided to the ground to avoid potential rise.

　　縫隙處理技術

　　Gap treatment technology

　　采用導電襯墊填充板縫，使用鈹銅指形簧片實現門框密封。經測試，處理后的板房氣密性提升GB/T 7106-2008標準的6級，電磁泄漏降低90%。

　　Fill the board seams with conductive pads and seal the door frame with beryllium copper finger springs. After testing, the airtightness of the processed panel room has been improved to level 6 of GB/T 7106-2008 standard, and electromagnetic leakage has been reduced by 90%.

　　三、增強型屏蔽材料應用

　　3、 Application of enhanced shielding materials

　　針對高頻段電磁干擾，需引入專用屏蔽材料：

　　For high-frequency electromagnetic interference, specialized shielding materials need to be introduced:

　　導電涂料噴涂

　　Conductive coating spraying

　　在板房內壁噴涂銀銅基導電涂料，厚度50-80μm，表面電阻<0.1Ω/□。對1GHz以上微波的屏蔽效能達60dB，同時保持墻面平整度。

　　Spray silver copper based conductive coating on the inner wall of the board room, with a thickness of 50-80 μ m and a surface resistance of<0.1 Ω/□. The shielding effectiveness against microwaves above 1GHz reaches 60dB, while maintaining wall flatness.

　　金屬網增強層

　　Metal mesh reinforcement layer

　　在彩鋼板夾層中嵌入不銹鋼絲網，網孔尺寸0.5mm×0.5mm，線徑0.2mm。形成三維導電網絡，提升低頻磁場屏蔽效能，對50Hz工頻干擾的衰減達30dB。

　　Embed stainless steel wire mesh with a mesh size of 0.5mm × 0.5mm and a wire diameter of 0.2mm in the interlayer of the color steel plate to form a three-dimensional conductive network, improve the shielding effectiveness of low-frequency magnetic fields, and attenuate 50Hz power frequency interference by 30dB.

　　屏蔽玻璃安裝

　　Installation of shielding glass

　　采用夾層鍍膜玻璃，膜層厚度15nm，可見光透過率>70%，電磁波反射率>95%。在保證采光的同時，阻斷電磁泄漏路徑。

　　Adopting laminated coated glass with a film thickness of 15nm, visible light transmittance>70%, and electromagnetic wave reflectivity>95%. Block electromagnetic leakage paths while ensuring natural lighting.

　　四、設備級防護設計

　　4、 Equipment level protection design

　　從設備端構建電磁防護體系：

　　Building an electromagnetic protection system from the device end:

　　電源凈化處理

　　Power purification treatment

　　安裝三級EMI濾波器，對差模干擾、共模干擾進行分級抑制。在10kHz-30MHz頻段，插入損耗>40dB，確保電源質量滿足G 151B軍用標準。

　　Install a three-level EMI filter to suppress differential mode interference and common mode interference in a graded manner. In the frequency range of 10kHz-30MHz, the insertion loss is greater than 40dB, ensuring that the power quality meets the G 151B military standard.

　　信號線防護

　　Signal line protection

　　對數據線、控制線采用屏蔽雙絞線，外裹鋁箔+編織網雙重屏蔽。在接口處安裝瞬態抑制二極管，防止雷擊浪涌侵入。

　　Shielded twisted pair cables are used for data and control lines, with double shielding of aluminum foil and braided mesh wrapped around them. Install transient suppression diodes at the interface to prevent lightning surges from entering.

　　設備布局優化

　　Equipment layout optimization

　　遵循“敏感設備隔離、干擾源分散”原則，將服務器、通信設備布置在板房中心區域，變頻器、大功率電機靠近外墻安裝，利用鋼結構天然屏蔽效應。

　　Following the principle of "isolation of sensitive equipment and dispersion of interference sources", servers and communication equipment are arranged in the central area of the prefabricated house, while frequency converters and high-power motors are installed near the exterior wall, utilizing the natural shielding effect of steel structures.

　　五、系統級維護管理

　　5、 System level maintenance management

　　建立電磁兼容的長期保障機制：

　　Establish a long-term guarantee mechanism for electromagnetic compatibility:

　　定期檢測校準

　　Regular testing and calibration

　　使用頻譜分析儀與近場探頭，每年對板房進行電磁兼容測試，監測10kHz-18GHz頻段。對屏蔽效能下降區域，及時補噴導電涂料或更換密封件。

　　Use a spectrum analyzer and near-field probe to conduct electromagnetic compatibility testing on the board room every year, with a focus on monitoring the 10kHz-18GHz frequency band. Timely apply conductive coating or replace sealing components in areas where shielding effectiveness has decreased.

　　接地系統維護

　　Grounding system maintenance

　　每季度檢測接地電阻，使用防腐導電膏處理連接點。在鹽霧腐蝕環境下，采用不銹鋼接地極，延長使用壽命20年。

　　Check the grounding resistance quarterly and use anti-corrosion conductive paste to treat the connection points. In salt spray corrosion environment, stainless steel grounding electrode is used to extend the service life to 20 years.

　　人員培訓認證

　　Personnel training certification

　　對板房使用人員進行電磁防護培訓，內容涵蓋設備操作規范、干擾識別方法、應急處理流程。確保每位操作人員持有電磁兼容上崗資格證。

　　Provide electromagnetic protection training for personnel using prefabricated houses, covering equipment operation specifications, interference identification methods, and emergency response procedures. Ensure that each operator holds an electromagnetic compatibility qualification certificate.

　　禹城鋼結構板房的電磁干擾防護，需融合材料科學、電氣工程、環境適應等多學科技術。通過發揮鋼結構天然屏蔽優勢、應用增強型屏蔽材料、實施設備級防護設計、建立系統級維護機制，可構建起全頻段、全天候的電磁防護體系。這種防護體系不僅保障電子設備穩定運行，更推動鋼結構建筑向智能化、化方向升級，成為信息化基礎設施的重要載體。

　　The electromagnetic interference protection of Yucheng steel structure slab houses requires the integration of multidisciplinary technologies such as materials science, electrical engineering, and environmental adaptation. By leveraging the natural shielding advantages of steel structures, applying enhanced shielding materials, implementing equipment level protection design, and establishing system level maintenance mechanisms, a full frequency and all-weather electromagnetic protection system can be constructed. This protective system not only ensures the stable operation of electronic devices, but also promotes the upgrading of steel structure buildings towards intelligence and safety, becoming an important carrier of information infrastructure.

　　本文由禹城鋼結構板房友情奉獻.更多有關的知識請點擊:http://fptdc.cn真誠的態度.為您提供為的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is a friendly contribution from Yucheng Steel Structure Plate House For more information, please click: http://fptdc.cn Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.